Microlife AG1-10 Navigation Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
7
c) Tighten the free end of the cuff and close the cuff
with the closer.
d) There must be no free space between the arm and
the cuff as this would influence the result. Clothing
must not restrict the arm. Any piece of clothing which
does (e.g. a pullover) must be taken off.
e) Secure the cuff with the closer in such a way that it
lies comfortably and is not too tight. Lay the arm on
the table (palm upwards) so that the cuff is at the
same height as the heart. Make sure that the tube is
not kinked.
f) Remain seated quietly for two minutes before you
begin the measurement.
Comment:
If it is not possible to fit the cuff to the left arm, it can also be placed on the right one. However
all measurements should be made using the same arm.
4.4. Measuring procedure
4.4.1. Put the chestpiece under the cuff
The chestpiece shall not be placed ON or INTO the cuff, it shall be
placed either under the cuff, or 1 - 2 cm below it. The chest piece
is then placed correctly , when the Korrot koff’s sound appears
strongest (‘loudest’). Make sure the chestpiece is in contact with
skin and above the brachial artery. Wear the binaural (earpieces)
properly to check the Korotkoff’s sound during measurement.
Before using the stethoscope, be sure there is no crack on the
diaphragm, earpieces, and tubing. Any improper setup or damage
of the stethoscope will cause distorted sound or poor sound
transmission to make inaccurate reading.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Comments to this Manuals

No comments