Microlife BP AG1-40 Instruction Manual download pdf (Page 12)

4.5.5. Record your readings

Repeat the measurement at least two times. Do not forget to record your readings and the time

of the day measurement is made immediately after you finish measuring. A suitable time is first

thing in the morning, or just before evening meals. Remember that your physician is the only

person qualified to analyze your blood pressure.

☞ Further information

Measurements should not occur soon after each other, since otherwise, the results will be

falsified. Therefore, wait for several minutes in a relaxed position, sitting or lying, before you

repeat a measurement.

5. Other possible malfunctions and their elimination

If problems occur when using the device, the following points should be checked and if

necessary,thecorrespondingmeasuresaretobetaken:

Malfunction

The sound transmission is

poor, distorted or there is

extraneous noise.

The pressure does not rise

although the bulb is pumping.

The deflation rate can not

be set to 2 - 3 mmHg/sec. by

adjusting the air release valve.

Remedy

1. Check the earpieces if they are plugged or cracked. If not,

make sure they do not fit poorly as worn.

2. Check the tube if it is broken or twisted.

3. Check the bell and diaphragm of chestpiece if there is any crack.

4. Make sure the chestpiece is in proper contact with skin and

over brachial artery during measuring. Clean or replace any

defective parts if found to avoid inaccurate reading.

1. Make sure that the valve is closed.

2. Make sure the cuff is properly connected to manometer.

3. Check if the cuff, tube and bulb is leaky. Replace the

defective parts if any.

•

Disassemble the valve from bulb to check if there is any blockage

in the airway of the valve. Clean the blockage and try again. If

it still does not work, replace it to avoid inaccurate reading

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

No comments

Microlife BP AG1-40 Instruction Manual Page 12